Sunday, March 11, 2012

Cyclopean delights

A while back I mentioned that RAFM had made a limited run of their 25mm Cyclops tri-wheels . I received mine a while back. Below are a few comments on the build so far.

The parts:


The vehicle body is a soft cast resin with the wheels, boiler top, smokestacks and small cannon in cast metal.  The body has a wonderful rough texture that gives a much nicer effect than flat plate would. The ventilation grid in particular had lots of crisp relief. This is the first resin cast I have worked with and I found it quite soft and easy to clean up. The boiler casting is clean and well detailed with rivets and re-enforcing bands. The smokestacks and gun were very basic and the stacks a bit rough in places. They do the job but I expect to replace them on future builds. The wheels however are works of art. Cleanly cast with no flash minimal mould lines and loaded with detail. I may try seeing if I can commission a run for other projects.

I had to heat the garage up beyond our sub-zero temperatures to undercoat with my usual grey automotive primer.  Drying took a long while and there was some bubbling on one model - entirely my fault.  For the first version, I decided to go stock, pretty much following the colour scheme on the website:

There is more dry brushing to do and more detailing possible but I am quite pleased with the results.  The next version will have a Martian dazzle scheme, tactical signs and perhaps some additional armament. The creative possibilities of this great little kit cannot be understated.

As for the rest of my Martian forces - I am not that great a figure painter so here is an arms length look:


 Yes - Lovecraft has put in an appearance stage centre. 

3 comments:

Herne said...

Looki9ng forward to see them in action!

PatG said...

Now we can move Tilley out.....

peter said...

It looks good so far!

Greetings
Peter
http://peterscave.blogspot.com/